Josh Pitts
New member
Hi all,
I have been having problems with my skid this week and not sure where to go from here..
I didn't run my machine for a week and when I went to run it, I didn't have any water at all. So I have a buddy that used to own a hydro tek and said that he would help me fix it. The ONLY thing that we did, was adjust the bypass/unloader valves.. at the time,we thought we'd fixed it, I had water. But didn't test anything else..
So now I went to do a job and went through my checklist before leaving, I have water, but when the gun is under load, I have no heat,and have water constantly streaming back into my float tank.
I also think that I broke the valves trying to adjust them.
Any help would be greatly appreciated.
Thanks in advance
Josh Pitts
I have been having problems with my skid this week and not sure where to go from here..
I didn't run my machine for a week and when I went to run it, I didn't have any water at all. So I have a buddy that used to own a hydro tek and said that he would help me fix it. The ONLY thing that we did, was adjust the bypass/unloader valves.. at the time,we thought we'd fixed it, I had water. But didn't test anything else..
So now I went to do a job and went through my checklist before leaving, I have water, but when the gun is under load, I have no heat,and have water constantly streaming back into my float tank.
I also think that I broke the valves trying to adjust them.
Any help would be greatly appreciated.
Thanks in advance
Josh Pitts